Screw air compressor maintenance process

Usually, the screw air compressor that everyone refers to mainly refers to the twin-screw air compressor. During the use of this type of air compressor, due to some improper habits, it is inevitable that some malfunctions will occur. In fact, there are many that we need to pay attention to, because some seemingly small problems also have the risk of causing the screw air compressor to shut down or even be scrapped. At this time, some reasonable operations such as maintenance are needed to deal with it. Usually, everyone must have come into contact with a lot of maintenance knowledge about screw air compressors, but I believe that many friends are not very clear about the specific steps of screw air compressor maintenance. Here I will share with you the operating steps for the maintenance of the entire screw air compressor. I hope that after reading this article, you can improve your hands-on maintenance skills. A. First, turn the screws in order to open the screw air compressor case. After opening, remove the damaged parts such as the bearings that need to be replaced. In order to ensure the wear resistance of the accessories, these accessories should be installed on a horizontal line; B. If it is necessary to check the screw air compressor oil circuit and related cooling system, the base of the screw air compressor is the key inspection area. It should be noted that the screw air compressor oil is in the area close to the base of the screw air compressor. In the base of the screw air compressor, there will be a panel to control the oil level;